The rims of your car get bent when it over runs any pothole or any sharp thing on the road. Initially you may feel only a bump but later on you realize that your car has you are losing the control of the car or it is drifting while driving.
Are the rims looking too bad?
Or
I am not able to drive normally; I think there is some problem with my car.
When customers come to us and use these statements, it is a sign that they have to get their car checked by the technicians.
Repairing The Rims
The technicians who repair the rims first diagnose for the level of damage. Once they are done with it they usually advice the customers about it and then start with the repairing. Almost every kind of rim can be straightened whether it is a bent car rim or the truck rim. Irrespective of whether it is a 15-inch rim or the 24-inch rim, it can be repaired without much problem.
Straightening A Bent Alloy Wheel
The alloy wheel bent repair is far more complicated than just hammering it to straighten. What may work for the steel may damage the alloy wheel. The straightening equipment which is used to repair the rims has gone a sea change as well. With time they have become very sophisticated.
Once the technicians start working on your rim, they will first start with removing the tyres from the rim. Doing this is necessary so as to avoid doing any damage to the tyres. The next step is attaching the wheel to the spun and marking is done next.
Once it is done then all the bends in the wheel are then gradually worked upon. The first machine the wheel is attached to usually take out the larger bends. The wheel in the machine is heated to higher temperatures. When it is hot enough the bends are then ironed out Straightening the Aluminum Wheels
When it comes to aluminum rim straightening the process is repeated as they have a memory and tend to go back to their original state. When all the large bends are removed, the wheel is then connected to the second straightening machine. It takes care of even the slightest bends. Finally, even the last bends are removed during the balancing.
So if you have bends in your machine whether they are small or large they can be repaired and it always better to get the repairing done as new rim may be very costly.
|